[Gate-users] Gate sometimes waits for nothing, why?

[Simon Stute]

Hi,

Just add the command /vis/disable at the beginning to fully disable the
visualization stuff.

Cheers,
Simon

On Fri, Oct 9, 2015 at 5:22 PM, Anders Garpebring <anders.garpebring at umu.se>
wrote:

> Dear gate users,
>
>
>
> Im working on running a batch of Gate simulations. To test my macro I want
> to run through all 28 simulation with just a single event for each
> simulation. However, the simulation often get stuck seemingly doing nothing
> for maybe 30 s. Why is this? Typically when I run just a single execution
> of my script it just takes a second or two. If I run it again immediately
> after it can take 30 seconds to finish.
>
>
>
> I get no errors but some warnings about the viewer (which I try to switch
> off).
>
>
>
> WARNING: Scene "none" not found.
>
>   /vis/scene/list to see scenes.
>
>
>
> WARNING: command "/vis/viewer/update" could not be applied: no current
> viewer
>
>
>
> In my code there are no references to the visualization.
>
>
>
> Best,
>
> Anders
>
> _______________________________________________
> Gate-users mailing list
> Gate-users at lists.opengatecollaboration.org
> http://lists.opengatecollaboration.org/mailman/listinfo/gate-users
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.opengatecollaboration.org/mailman/private/gate-users/attachments/20151015/8bd301f6/attachment.html>