[Gate-users] How to create this - slant hole in a plate

[Vesna Cuplov]

Hello,

I see from the following page:

http://geant4.web.cern.ch/geant4/UserDocumentation/UsersGuides/ForApplicationDeveloper/html/ch04.html

that what you might need is the G4CutTubs. This has not been implemented in
Gate but you could
try to implement it by following how other volumes were added.

vesna

On Wed, Mar 6, 2013 at 4:59 PM, Simon Stute <gate.stute at gmail.com> wrote:

> Some precisions:
>
> My solution is not strictly correct. It will be correct only if you have
> air around your plate, for at least the same dimensions as those of the
> piece of cylinder that goes outside the plate.
> Also, you will have ellipses cross-sections between the plate borders and
> the cylinder.
>
> Cheers,
> Simon
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.opengatecollaboration.org/mailman/private/gate-users/attachments/20130306/9dfa266e/attachment.html>