[Gate-users] Cylindric PET output, sinogram, LMF

[David Boersma]

Hi Robert,

I am not the relevant expert to answer your question, but I can suggest 
that you specify in a bit more detail what you attempted and where you 
got stuck.

[In general, writing to a mailing list that "it does not work" is not 
the most efficient way to solve your problem. In this situation, it's 
better to provide too many details (experts can pick the important bits 
out of the mess) than too few.]

For instance:

* Which version of Gate are you using?

* What are the versions of: gcc, geant4, ROOT, linux/macosx?

* Did you manage to install the LMF library? Which version?

* Was LMF actually enabled when compiling Gate?
(Gate can be built without LMF support, and the build system won't warn 
you for that.)

* If you have a running Gate setup, then what exactly did you do to get 
the LMF output, and which which messages/warnings/errors did you get 
from Gate when you ran it?

HTH,
David Boersma

Den 13/09/2016 kl. 12:20, skrev Robert Bagaric:
> Dear all,
>
> does LMF output works? I cannot make it work.
>
> I would like to have sinogram and LMF output on my "Raytest ClearPET"
> cylindrical model. Is that possible?
>
> Best regards,
>
> --
> /
> /
> /Robert Bagaric, dipl. eng. ele./
> /Department of Experimental Physics/
> /Ruder Boskovic Institute/
> /
> /
>
>
> _______________________________________________
> Gate-users mailing list
> Gate-users at lists.opengatecollaboration.org
> http://lists.opengatecollaboration.org/mailman/listinfo/gate-users
>