[Gate-users] Problem with trapezoidal geometry Gate v6.2

[S. Saghamanesh]

Hi,
I could create a trapezoidewith slanted angles through "trpd" not " trap" in Gate7.0 , but it seems the Gate manual has some ambiguity in describing this volume. some of its parameters don't make sense.

Cheers
Soman



On Wednesday, August 20, 2014 10:22 AM, "Valenciaga, Yanisley" <YValenciaga at mednet.ucla.edu> wrote:
 


 
Dear all,
 
I need to create a trapezoidal geometry where each four sided faces have different slanted angles. I tried using TRAP, but this one only allows to address the angle of 2 opposite faces only. The user guide mentions “Boolean logic” to create complex geometries, but I haven’t made this work either.
 
Any suggestions?
 
 
 
Best Regards,
Yanisley
 
Yanisley Valenciaga
Biomedical Physics Ph.D Student
University of California, Los Angeles (UCLA)
 
________________________________
 
IMPORTANT WARNING: This email (and any attachments) is only intended for the use of the person or entity to which it is addressed, and may contain information that is privileged and confidential. You, the recipient, are obligated to maintain it in a safe, secure
 and confidential manner. Unauthorized redisclosure or failure to maintain confidentiality may subject you to federal and state penalties. If you are not the intended recipient, please immediately notify us by return email, and delete this message from your
 computer.
 
_______________________________________________
Gate-users mailing list
Gate-users at lists.opengatecollaboration.org
http://lists.opengatecollaboration.org/mailman/listinfo/gate-users
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.opengatecollaboration.org/mailman/private/gate-users/attachments/20140820/6b8ce4e4/attachment.html>