[Gate-users] updating geometry in Gate 6.1

[Shruti Agarwal]

Thanks!

Gate gives me the following error when I use ellipso geometry:

------------------
parameter value is not listed in the candidate List.
***** Illegal parameter (0) </gate/world/daughters/insert ellipso> *****

***** Batch is interrupted!! *****
---------

GATE provides option to design truncated sphere and cone by the use of
DeltPhi parameter. Is it possible to design truncated / half ellipsoid in
GATE ?

please explain.

Thank you.

Shruti




On Tue, Jun 28, 2011 at 5:10 AM, Simon Stute <gate.stute at gmail.com> wrote:

> Hey,
>
> On Mon, Jun 27, 2011 at 6:52 PM, Shruti Agarwal <sbansal.iitk at gmail.com>wrote:
>
>> Hi,
>>
>> I installed GATE 6.1 correctly. I have two questions about running:
>>
>> 1) the gate prompt is idle> instead of preInt>, is it a problem of Gate
>> 6.1
>> running?
>>
>>
> Not a problem. it is normal.
>
>
>> 2) In Gate 6.1, I used /gate/geometry/update. Gate give the following
>> error
>>
>> ***********COMMAND NOT FOUND </gate/geometry/update>*********
>>
>> I could see the geometry only after I have put the following:
>> /gate/run/initialize
>>
>
> Do I have to do it every time I want to visualise the geometry? please
>> explain.
>>
>>
> Just use the /gate/geometry/rebuild command. Sorry if the documentation is
> wrong.
>
> Cheers,
> Simon
>
>
>> Thank you.
>>
>> Shruti
>> _______________________________________________
>> Gate-users mailing list
>> Gate-users at lists.opengatecollaboration.org
>> http://lists.opengatecollaboration.org/mailman/listinfo/gate-users
>>
>
>