[Gate-users] Slice time displays as 1+e07 on command line

[Marc Chamberland]

Hi!

I believe there is a little bug in the display of the time slice information in Gate v6.0.p01 (at least, I think it's a bug). When I run my simulations, it displays the following:

[Acquisition-0] ============= Source initialization =============
[Acquisition-0]                                      
[Acquisition-0] ============= Acquisition starts! =============
[Acquisition-0] Simulation start time = 0 sec
[Acquisition-0] Simulation end time   = 10 sec
[Acquisition-0] Simulation will have  = 1000 run(s)
[G4] Slice n° 0  | Time: 1e+07
[G4] Slice n° 1  | Time: 1e+07
[G4] Slice n° 2  | Time: 1e+07
[G4] Slice n° 3  | Time: 1e+07
[G4] Slice n° 4  | Time: 1e+07
[G4] Slice n° 5  | Time: 1e+07
[G4] Slice n° 6  | Time: 1e+07
[G4] Slice n° 7  | Time: 1e+07
[G4] Slice n° 8  | Time: 1e+07
[G4] Slice n° 9  | Time: 1e+07
[G4] Slice n° 10  | Time: 1e+07
[G4] Slice n° 11  | Time: 1e+07
[G4] Slice n° 12  | Time: 1e+07
[G4] Slice n° 13  | Time: 1e+07
[G4] Slice n° 14  | Time: 1e+07
[G4] Slice n° 15  | Time: 1e+07
[G4] Slice n° 16  | Time: 1e+07


I think this should be displaying the actual time of the time slices, e.g.:

Time: 0.00
Time: 0.01
Time: 0.02
etc.

It doesn't seem to have any effect on the actual simulation, though.


Marc Chamberland, MSc
PhD candidate (Medical Physics)
Department of Physics
Carleton University
Ottawa (ON)

mchamber at connect.carleton.ca