[Gate-users] PreInit mode in vGATE

[Simon Stute]

Hi,

Gate_v6_p01 is installed in vGate and in this version the command
/gate/geometry/enableAutoUpdate is outdated.
If you want to build interactively your geometry, please use the
/gate/geometry/rebuild command to update your visualization each time you
need it.
And don't worry about the Idle state instead of PreInit, everything is
normal :-)

Cheers,
Simon

On Thu, Apr 29, 2010 at 3:01 PM, Navid Zeraatkar
<navid_zeraatkar at yahoo.com>wrote:

> Dear Gaters
>
> I have just started vGATE. But I wonder when I type "Gate" in terminal to
> start, it begins in "Idle" mode instead of "PreInit" mode. So no
> visualization works in it. For instance, the command
> "/gate/geometry/enableAutoUpdate" is not applicable and the error "Command
> not Found" is appeared. Any help is appreciated.
>
> Regards
>
>
>
> ________________________________
>
> Navid Zeraatkar
> MSc Student, Department of Radiation Medicine Engineering, Shahid Beheshti
> University of Tehran
> Member of Medical Imaging Systems Research Group, Research Center for
> Science and Technology in Medicine (RCSTIM), Tehran University of Medical
> Sciences
> Email: na.zeraatkar at mail.sbu.ac.ir
>          navid_zeraatkar at yahoo.com
> Tel: +9821 66581563
> Mobile: +989102114574
>
>
>
> _______________________________________________
> Gate-users mailing list
> Gate-users at lists.opengatecollaboration.org
> http://lists.opengatecollaboration.org/mailman/listinfo/gate-users
>