[gate-users] Root Output

[Claude Comtat]

Dear Simone, Els and Long,

strange behavior; here, with Redhat 9.0 and root 3.10, both OpenGL 
visualization and root outputs are working together. I do not think we 
tried with Redhat 8 (jumped directly from 7.3 to 9.0)

When you said "root output", did you refer to both "root output" 
(G4ANALYSIS_USE_ROOT) and "root real-time plotter" 
(G4ANALYSIS_USE_ROOT_PLOTTER) ? If you disable only the root real-time 
plotter, does OpenGL work ?

Could you please give us

1) your env_gate.csh file
2) the full output of "source env_gate.csh"
3) your macros
4) the full output of Gate running

Best regards,

Claude

Els Wieërs wrote:

>Dear all,
>
>It's all in the macro. But when I run Gate I get the following errors:
>***** COMMAND NOT FOUND </gate/output/root/enable> *****
>***** Command ignored *****
>***** COMMAND NOT FOUND </gate/output/root/setFileName MyRootFileName test1>
>*****
>***** Command ignored *****
>***** COMMAND NOT FOUND </gate/output/root/setRootSinglesFlag 1> *****
>***** Command ignored *****
>etc...
>It's obivious that the Root output doesn't work although everything should
>be installed just right (see mail below)
>Any other suggestions?
>Greets
>Els
>
>ps: the macro is in the attachement
>
>Dear all,
>
>Sorry, my fault. It should be "might" can't work with root output enabled.
>
>It may caused by difference between Redhat 8.0 and Redhat 9.0 (purly guess). On
>Redhat 8.0, it can't work ( two of my Redhat 8.0 Linux box can't work ). Redhat
>9.0, I don't know, but I remember David Schottlander (dcs at robots.ox.ac.uk) had
>told me that there is no problem on his Redhat 9.0 box.
>
>Regards,
>
>Long
>
>Dear Claude,
>
>I can't run simultaneous OpenGL and root output either; please see the
>discussion "vis problem: Command not found".
>
>Best regards,
>Simone
>
>