<div dir="ltr"><div>Hi,</div><div><br></div><div>I was simulating a X-ray imaging process with 2 x 10^9 events. It has been running over 5200 minutes and still ongoing. From the output I saw the following warning message about "Track stuck or not moving" as attached below (multiple times). However, when I ran 2 x 10^7 events I did not have the same warming issue and the simulation was completed < 20 hours successfully. Should I worry about this warning or just ignore it and continue to wait? Thanks a lot!</div><div><br></div><div>Howard</div><br><div>-------- WWWW ------- G4Exception-START -------- WWWW -------<br>*** G4Exception : GeomNav1002<br>      issued by : G4Navigator::ComputeStep()<br>Track stuck or not moving.<br>          Track stuck, not moving for 10 steps<br>          in volume -world_phys- at point (-5.649999594721559,4.81816525126774,-38.09301491743752) (local point (-5.649999594721559,4.81816525126774,-38.09301491743752))<br>          direction: (0.6222482514791153,-0.3555437239478714,0.6974208011612956) (local direction: (0.6222482514791153,-0.3555437239478714,0.6974208011612956)).<br>          Potential geometry or navigation problem !<br>          Trying pushing it of 1e-07 mm ...Potential overlap in geometry!<br><br>*** This is just a warning message. ***<br>-------- WWWW -------- G4Exception-END --------- WWWW -------<br></div></div>